View MB4204_146584.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

FUJITSU SEMICONDUCTOR DATA SHEET
DS04-12104-2E
LINEAR IC
QUAD COMPARATOR
MB4204
LOW POWER QUAD COMPARATOR
The Fujitsu MB4204 is a Quad Comparator which consists of four independent channels. The MB4204 is designed to operate form either a single power or dual power supplies over a wide range of voltages. The input characteristics is equivalent of current industry standard comparator. Even though operated from a single power supply, the MB4204 is suitably designed to compare multiple signals in parallel and to be operated with battery because its input common mode voltage range includes ground potential and it requires low power supply current. The MB4204 can be high density mounted because it integrates 4 circuits on a chip in DIP/FPT-14-pin package. The MB4204 is pin compatible with LM339.
s FEATURES
* * * * * * * Wide power supply voltage range: +2 to +36V Wide input common mode range: 0 to (VCC - 1.5) V Low power supply current: 0.8 mA typ. Low input offset voltage: 2 mV typ. Low input bias current: 25 nA typ. Open Collectors Output allow to wired-OR Connection Package --14-pin Plastic DIP Package (Suffix: -P) --14-pin Plastic FPT Package (Suffix: -PF)
s PACKAGES
PLASTIC PACKAGE DIP-14P-M02
PLASTIC PACKAGE FPT-14P-M04
This device contains cirduitry to protect the inputs against damage due to high static voltages or electric fields. However, it is advised that normal precautions be taken to avoid application of any voltage higher than maximum rated voltages to this high impedance circuit.
1
MB4204
s ABSOLUTE MAXIMUM RATINGS (see NOTE)
Rating Power Supply Voltage Power Dissipation Differential Input Voltage Common Mode Input Voltage Output Short Circuit Duration Operating Temperature Storage Temperature Symbol VCC PD VID VI -- TA TSTG Value 36 500 36 -0.3 to +36 Infinite -20 to +75 -55 to +125 (TA = 25C) Unit V mW V V -- C C
NOTE: Permanent device damage may occur if the above Absolute Maximum Ratings are exceeded. Functional operation should be restricted to the conditions as detailed in the operational sections of this data sheet. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
s PIN ASSIGNMENT
OUT-B OUT-A
1 2 3 -+ 4 5 6 7 -+ -+ -+
14 13 12 11 10 9 8
OUT-C OUT-D GND +IN-D -IN-D +IN-C -IN-C
VCC
-IN-A +IN-A -IN-B +IN-B
(TOP VIEW)
2
MB4204
Fig. 1 -- EQUIVALENT CIRCUIT
VCC 3
-IN-A 4
+IN-A-IN-B 5 6
+IN-B-IN-C 7 8
-IN-C-IN-D 9 10
+IN-D 11
12 GND
2 OUT-A
1 OUT-B
14 OUT-C
13 OUT-D
3
MB4204
s ELECTRICAL CHARACTERISTICS
(VCC = +5 V, TA = 25C) Value Unit Typ. Max. 2 5 25 -- 200 13 300 1.3 250 16 0.1 -- 0.8 5 50 250 VCC - 1.5 -- -- -- -- 400 -- -- 1 2 mV nA nA V V/ mV mho s ns s mV mA nA A mA
Parameter Input Offset Voltage Input Offset Current Input Bias Current Input Common Mode Voltage Voltage Gain Transconductance Large Signal Response Time Response Time Output Saturation Voltage Output Sink Current Output Leakage Current Output Leakage Current Power Supply Current
Symbol VIO IIO II*
1
Condition VO = VREF = 1.4 V -- -- -- RL = 15 k -- RL = 5.1 k, VRL = 5 V RL = 5.1 k, VRL = 5 V VIN(-) = 1 V, VIN(+) = 0 V, ISINK = 3 mA VIN(-) = 1 V, VIN(+) = 0 V, VO 1.5 V VIN(+) = 1 V, VIN(-) = 0 V, VO = 5 V VIN(+) = 1 V, VIN(-) = 0 V, VO = 30 V RL =
Min. -- -- -- 0 -- -- -- -- -- 6 -- -- --
VCM AV -- *2 *
3
VOL ISINK ILEAK ILEAK ICC
Notes: *1: The direction of the input bias current flows from IC. *2: VIN = TTL Logic Swing, VREF = 1.4 V *3: VIN = 100 mV, Overdrive = 5 mV
4
MB4204
Fig. 2 -- TEST CIRCUIT
VCC VRL VCC
5V
VIN(+) VIN(-)
+ -
RL VO PG
- +
RL = 5.1k VO
VREF VREF sets over drive level.
s TYPICAL CHARACTERISTICS CURVES
Fig. 3 -- Power Supply Current vs. 1.6 TA (C) -20 1.2 25 70 0.8 10 3 1 0.3 0.1 0.03 0.4 0.01 0.003 0 0 10 20 30 40 Power Supply Voltage VCC (V) Fig. 5 -- Input/Output Voltage vs. 6 Input Over Drive 4 2 0 0 TA = 25C -100 0 0.5 1.0 Time (s) 1.5 2.0 0 0 0.5 1.0 Time (s) 1.5 2.0 5 mV 20 mV 100 mV 0 100 TA = 25C 4 20 mV 2 5 mV 6 TA = -20C TA = 70C TA = 25C Fig. 4 -- Output Saturation Voltage vs.
0.001 0.01 0.03 0.1 0.3 1
3 10 30 100
Output Sink Current ISINK (mA) Fig. 6 -- Input/Output Voltage vs. 100 mV Input Over Drive
5
MB4204
s PACKAGE DIMENSIONS
14 pin, Plastic DIP (DIP-14P-M02)
19.55 -0.30
+0.20 +.008
.770 -.012
INDEX-1 INDEX-2 6.200.25 (.244.010)
4.36(.172)MAX
0.51(.020)MIN 0.250.05 (.010.002)
3.00(.118)MIN
0.460.08 (.018.003)
+0.30 +.012 -0
1.52 -0 2.40(.094) MAX
.060 2.54(.100) TYP
7.62(.300) TYP
15MAX
C
1994 FUJITSU LIMITED D14010S-4C-3
Dimensions in mm (inches).
(Continued)
6
MB4204
(Continued)
14 pin, Plastic SOP (FPT-14P-M04)
2.25(.089)MAX 10.15 -0.20 .400 -.008
+0.25 +.010
0.05(.002)MIN (STAND OFF)
INDEX
5.300.30 (.209.012) "B"
7.800.40 (.307.016)
6.80 -0.20 +.016 .268 -.008
+0.40
1.27(.050) TYP
0.450.10 (.018.004)
O0.13(.005)
M
0.15 -0.02 +.002 .006 -.001 Details of "A" part 0.40(.016)
+0.05
0.500.20 (.020.008)
Details of "B" part 0.15(.006) 0.20(.008)
"A" 0.10(.004) 7.62(.300)REF
0.20(.008) 0.18(.007)MAX 0.68(.027)MAX 0.18(.007)MAX 0.68(.027)MAX
C
1994 FUJITSU LIMITED F14010S-2C-4
Dimensions in mm (inches).
7
MB4204
FUJITSU LIMITED
For further information please contact:
Japan FUJITSU LIMITED Corporate Global Business Support Division Electronic Devices KAWASAKI PLANT, 4-1-1, Kamikodanaka Nakahara-ku, Kawasaki-shi Kanagawa 211-8588, Japan Tel: (044) 754-3763 Fax: (044) 754-3329
All Rights Reserved. The contents of this document are subject to change without notice. Customers are advised to consult with FUJITSU sales representatives before ordering. The information and circuit diagrams in this document presented as examples of semiconductor device applications, and are not intended to be incorporated in devices for actual use. Also, FUJITSU is unable to assume responsibility for infringement of any patent rights or other rights of third parties arising from the use of this information or circuit diagrams. FUJITSU semiconductor devices are intended for use in standard applications (computers, office automation and other office equipment, industrial, communications, and measurement equipment, personal or household devices, etc.). CAUTION: Customers considering the use of our products in special applications where failure or abnormal operation may directly affect human lives or cause physical injury or property damage, or where extremely high levels of reliability are demanded (such as aerospace systems, atomic energy controls, sea floor repeaters, vehicle operating controls, medical devices for life support, etc.) are requested to consult with FUJITSU sales representatives before such use. The company will not be responsible for damages arising from such use without prior approval. Any semiconductor devices have inherently a certain rate of failure. You must protect against injury, damage or loss from such failures by incorporating safety design measures into your facility and equipment such as redundancy, fire protection, and prevention of over-current levels and other abnormal operating conditions. If any products described in this document represent goods or technologies subject to certain restrictions on export under the Foreign Exchange and Foreign Trade Control Law of Japan, the prior authorization by Japanese government should be required for export of those products from Japan.
http://www.fujitsu.co.jp/
North and South America FUJITSU MICROELECTRONICS, INC. Semiconductor Division 3545 North First Street San Jose, CA 95134-1804, USA Tel: (408) 922-9000 Fax: (408) 922-9179 Customer Response Center Mon. - Fri.: 7 am - 5 pm (PST) Tel: (800) 866-8608 Fax: (408) 922-9179
http://www.fujitsumicro.com/
Europe FUJITSU MIKROELEKTRONIK GmbH Am Siebenstein 6-10 D-63303 Dreieich-Buchschlag Germany Tel: (06103) 690-0 Fax: (06103) 690-122
http://www.fujitsu-ede.com/
Asia Pacific FUJITSU MICROELECTRONICS ASIA PTE LTD #05-08, 151 Lorong Chuan New Tech Park Singapore 556741 Tel: (65) 281-0770 Fax: (65) 281-0220
http://www.fmap.com.sg/
F9803 (c) FUJITSU LIMITED Printed in Japan
8

▲Up To Search▲

Price & Availability of MB4204

	To Download MB4204 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .